Hello everyone, I have a large 3D model which I have already optimized to the maximum by splitting it by trade and by exporting it to DWF which usually gives the smallest file sizes of all the formats I've tried (including spx). But due to the project's nature it sill remains a bit heavy and I was hoping the "Tesellation" option on Import could help. I have tried many options from Tesselation = 1 up to 10 but I didn’t see any change in file size (not reduced, or increased) nor any change in apparence or fluidity of the geometry. The expected result of a lower tessellation value for me would be a synchro file which, Ideally, would have roughly the same size as the imported DWF or even lower if possible, and a better fluidity when navigating in the file. If this is not the case, what should I expect? And in general is there any other way to optimize my file sizes within Synchro? Thanks!
↧